Post Installation Checklist - Avaya J129 Installing And Administering

If the phone does not receive a provisioning server address from the configuration
setup, the phone displays the Configure Provision Server screen.
c. In the Configure Provision Server screen, press the Config softkey and enter the
address of the provisioning server. The provisioning server address can be in the form
of IP address or a Fully Qualified Domain Name (FQDN). To enter the dot symbol (.) in
the field, press the alphanumeric softkey to toggle to the alphanumeric mode.
d. The phone verifies the VLAN ID, and starts tagging the data and voice packets
accordingly.
e. The phone sends and identifies an upgrade script file, gets the Settings file, the
language files, and any firmware updates.
• If configured to use simple certificate enrollment protocol (SCEP), the phone
downloads a valid device certificate.
• The phone displays only the Admin softkey for 15 seconds, and then the Admin and
the Login softkeys.
Note:
For subsequent restarts, if the user login is automatic and the supplied
credentials are valid, the Login softkey is not displayed.
4. Do one of the following:
• To access the user login screen, press the Login softkey.
• To access the Admin menu, press the Admin softkey and enter the admin menu
password.

Post installation checklist

To ensure that the phone is properly installed and running properly, verify that the following
requirements are complete.
No. Task
1 Has the phone acquired an IP address?
2 Are you able to make a call from the
phone?
3 Are you able to modify the phone's
Settings file parameters and end user
settings.
4 Are you able to upgrade your phone?
September 2017
Reference
List of configuration
parameters
Device upgrade
process
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
Post installation checklist
on page 87
on page 70
Table continues...
25