Avaya J129 Installing And Administering page 94

List of configuration parameters
Parameter name
DHCPSTAT
DHCPSTD
DIALPLAN
DISCOVER_AVAYA_ENVIRONM
ENT
September 2017
Default value Description
1 Specifies whether DHCPv4, DHCPv6, or both will
be used in case IPv6 support is enable by using
IPV6STAT.
Value operation:
• 1: Run DHCPv4 only. IPv4only-mode, if no own
• 2: Run DHCPv6 only. Pv6only-mode, if no own
• 3: Run both DHCPv4 & DHCPv6. Dual-stack
Value 2 or 3 run both DHCPv4 and DHCPv6.
0 Specifies whether DHCP complies with the IETF
RFC 2131 standard.
Value Operation:
• 0: Continue using the address in an extended
• 1: Immediately stop using the address.
Null Specifies the dial plan used in the phone.
Dialplan accelerates dialing by eliminating the need
to wait for the INTER_DIGIT_TIMEOUT timer to
expire.
The value can contain 0 to 1023 characters. The
default value is null.
Specifies dynamic feature set discovery
Value Operation:
• 1: The phone discovers and verifies if the
• 0: The phone operates in a mode where AST
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
IPv6 address is programmed statically
IPv4 address is programmed statically
mode
rebinding state.
controller supports the AST feature set or not.
The phone sends a SUBSCRIBE request to the
active controller for the Feature Status Event
Package (avaya-cm-feature-status). If the
request succeeds, the phone proceeds with PPM
Synchronization. If the request is rejected, or is
proxied back to the phone, or does not receive a
response, the phone assumes that AST features
are not available.
features are not available.
Table continues...
94