Avaya J129 Installing And Administering page 121

Parameter name
RTCPMON
RTCPMONPERIOD
RTCPMONPORT
RTP_PORT_LOW
RTP_PORT_RANGE
S
SCEPPASSWORD
SDPCAPNEG
September 2017
Default value Description
Null Specifies the IP or DNS address for the RTCP
monitor.
You can set this parameter only if the environment
is not an Avaya environment. The values can
range from 0 through 255 characters.
5 Specifies the interval, in seconds, for sending out
RTCP monitoring reports. Valid values are from 5
to 30 seconds.
5005 Specifies the RTCP monitor port number.
You can set this parameter only if the environment
is not an Avaya environment. The values can
range from 0 through 65535. Default is 5005.
Specifies the lower limit of the UDP port range to
be used by RTP or RTCP and SRTP or SRTCP
connections.
The values can range from 1024 through 65503.
Specifies the range or number of UDP ports
available for RTP or RTCP and SRTP or SRTCP
connections
This value is added to RTP_PORT_LOW to
determine the upper limit of the UDP port range.
The values can range from 32 through 64511.
$SERIALNO Specifies the password to be included in the
challengePassword attribute of an SCEP certificate
request.
Values can contain 0 to 32 ASCII characters (50
ASCII characters.
If the value contains $SERIALNO, it is replaced by
the phone's serial number. If the value contains
$MACADDR, it is replaced by the phone's MAC
address in hex.
1 Specifies if SDP capability negotiation is enabled.
Installing and Administering Avaya J129 IP Phone
Comments on this document? infodev@avaya.com
Note:
• A password prompt is invoked when SCEP
is set for identity certificate enrollment and
the parameter value is empty.
• This parameter must not be set in a file that
is accessible on an enterprise network, and
only in a restricted staging configuration.
Table continues...
121