View Or Reset Job Timer (Jtime) - New Holland L213 Operator's Manual

3 - CONTROLS AND INSTRUMENTS

View or reset Job Timer (JTIME)

NOTE: The Advanced Instrument Cluster (AIC) images are shown in this section for the four switch buttons (2), (3),
(4), and (5) used to navigate through the instrument cluster. The top two switch buttons on the Electronic Instrument
Cluster (EIC) are function buttons and function the same as the POWER (5) and START (2) switch buttons on the
AIC instrument panel for the setup menu functions.
The operator may choose to set a timer that will run in-
dependent from the machine hours. To view or reset the
timer:
Once in the "Setup" menu, press the START button until
JTIME appears on the screen.
1. Push the POWER button (5) to view the current timer.
2. Push the START button (2) to reset or view the timer.
3. Use the POWER button (5) to save the selection.
1
RAIL15SSL0143CA
3-58