New Holland L213 Operator's Manual page 221

Skid steer loader. compact track loader
Hide thumbs Also See for L213:
Table of Contents

Advertisement

7. Place a drain receptacle under the machine.
NOTE: After the quick-disconnect hose installation, oil will
automatically begin to flow out of the hose.
8. Thread the quick-disconnect hose assembly (1) onto
the quick-disconnect drain fitting (2).
9. Allow the oil to drain completely from the crankcase.
10. Remove the receptacle, with the used oil, from under
the machine.
11. Dispose of the oil in accordance with the local regula-
tions.
12. Turn the old engine oil filter counter-clockwise to re-
move.
13. Dispose of the filter in accordance with the local reg-
ulations.
14. Use a clean cloth and wipe sealing surface of the old
filter base to remove all dirt.
15. Apply a thin layer of clean grease or oil to the gasket
of the new filter.
16. Turn the new oil filter clockwise onto the base until
the gasket makes contact with the base. Continue to
tighten the filter with your hand for 3/4 to one full turn
as directed on the filter label.
NOTICE: DO NOT use a filter strap wrench to install the oil
filter. An oil filter strap wrench can cause a leak if the filter
is dented or overstressed.
17. Remove the quick-disconnect hose assembly (1) from
the quick-disconnect drain fitting (2).
7 - MAINTENANCE
7-57
5
RAPH17SSL0170QA
6
RAPH17SSL0170QA

Advertisement

Table of Contents
loading

This manual is also suitable for:

200 seriesL223L215L225L218L230 ... Show all

Table of Contents