1. Connect all slings to a single point (1) on the suitable
craning equipment above the cab.
2. Attach chains to the machine's rear lifting points (2) on
the machine.
3. Route the front sling down the right-hand side of the
Roll Over Protective Structure (ROPS).
4. Route the front sling down the outside of the ROPS
front pivot point (1) and attach to the machine's right-
hand side lifting point (2).
5. Repeat on the left-hand side of the machine.
6. Clear the area.
7. Lift the machine just off the ground. The machine
should stay level. If it is not level lower the machine
to the ground and adjust the length of the rear chains.
Repeat until you achieve a level lift.
5 - TRANSPORT OPERATIONS
5-7
12
RAIL14SSL0397BA
13
RAIL14SSL0395BA
14
RAIL14SSL0396BA