New Holland L213 Operator's Manual page 114

Setting custom controllability settings for Electro–Hydraulic (EH)
NOTE: These settings can be activated using the Easy Electro-Hydraulic (EZ-EH) menu custom settings SP-C and
CR-C.
All changes must be made with the engine in the off posi-
tion and the electronics asleep.
1. Before sitting in the seat, press and hold the AUX
OVERRIDE button (4) and the OPERATE button (3) at
the same time for five to seven seconds until SETUP
(1) appears in the display. After seeing setup in the
display, you may sit in the operator's seat and make
changes.
2. Press the START button (2) to scroll between the dif-
ferent menus until EH (1) appears on the display.
3. Press the POWER button (5) to enter the next menu.
4. Press the START button (2) to scroll to the setting se-
lection you want to adjust (Speed: Drive, Lift, or Tilt) or
(CTLR: Drive or L-ARM), then press the POWER but-
ton (5) to save the entry. For DFLT, press the POWER
button (5) to save the settings back to the factory de-
fault settings. The default settings are shown in tables
for each model on the following pages.
NOTE: Use the AUX OVERRIDE button (4) when you
want to go up a level.
5. Press the START button (2) to scroll to the desired
speed level (High, Med-2, Med-1, or Low) or (DRV1,
DRV2, or DRV3) or (LDR1, LDR2, or LDR3), then
press the POWER button (5) to save the entry.
6. After you have saved your selection; the monitor will
revert back to step 3 so you can make another ad-
justment. If no other adjustments are needed, use the
AUX OVERRIDE button (4) to exit the machine func-
tion menu. You will now be in the main SETUP menu;
use the START button (2) to scroll to EXIT and then
push the POWER button (5) again to exit the setup
menu.
7. Leave the operator's seat for ten seconds before trying
to start the unit.
3 - CONTROLS AND INSTRUMENTS
3-54
4
RAIL15SSL0143CA