New Holland L213 Operator's Manual page 248

WARNING
Crushing hazard!
Never use the machine lift arms or attachment
to raise the machine for service. Use adequate
blocking to ensure the machine is supported
safely with all four wheels off the ground.
Failure to comply could result in death or seri-
ous injury.
18. Block the machine up so that the tires are just off the
ground, a maximum of 25 mm (1.0 in) above the sur-
face.
19. Do periodic checks for protection. Look for corrosion.
Storage removal
1. If machine is blocked, lower it to the ground.
2. Change the fuel filters and fill the fuel tank if needed.
3. Tighten the cooling system drain valves.
4. Fill engine coolant system.
5. Check engine oil level.
6. Check the condition of the engine fan belt. Replace it
if required.
7. Check the hydraulic fluid level.
8. Lubricate the machine grease fittings.
9. Use a petroleum base solvent and remove the rust and
corrosion preventive from the hydraulic cylinder rods
and spools, etc.
10. Install a fully charged battery.
NOTE: Check the battery periodically for the correct elec-
trolyte level. Wear face protection and test the electrolyte
with a hydrometer. When the hydrometer reading is near
1.215, charge the battery.
11. Remove air from the engine fuel lines.
12. Prime the turbocharger oil lines with oil using the fol-
lowing procedure:
• Disconnect the electrical connector to the injection
pump solenoid. This will prevent the engine from
starting.
• Make sure all persons are clear of the machine.
Actuate the starter for about 10 s to 15 s.
• Reconnect the wires to the injection pump solenoid.
NOTE: Before starting the engine, make sure there are no
leaks, missing or broken parts.
13. Start the engine and run at idle speed for 2 min.
Check for leaks around the filters and drain plugs.
7 - MAINTENANCE
W0345A
7-84