New Holland L213 Operator's Manual page 235

L213, L215, L223, L225, and L230 models only
1. Park the machine on firm level surface.
NOTE: For Models L213 and L215 only: Raise the machine enough to remove the wheels and block the machine
with support blocks to secure the machine in a level position. Remove the front right wheel and the rear left wheel
from the machine to access the chain tank fill/level plug (1).
2. Clean the area around the chain tank drain plugs (not
shown), located on the bottom of the drive chain tank,
near the rear of the drive chain tank, one on each side.
3. Clean the area around the chain tank fill/level plug (1).
4. Place a suitable container under the chain tank and
slowly remove the tank drain plug.
NOTE: Use a jack and raise the front of the machine slightly
for better draining.
5. Remove the chain tank fill/level plug (1).
6. After the oil has been completely drained, replace the
chain tank drain plug.
7. Fill the tank with new oil and replace the chain tank
fill/level plug (1).
NOTE: Use L ® 545™ or an equivalent product on
OCTITE
the thread of the plugs.
8. Repeat this procedure for the other side.
NOTE: The chain tank may be cleaned with a solvent based cleaner by removing the inspection cover (2) on each
side, after the oil has been removed. Allow the tank to dry thoroughly before filling with oil.
Capacity - each side
L213, L215
L223, L225, L230
7 - MAINTENANCE
7-71
2
RCPH11SSL006AAD
6.25 l (6.6 US qt)
22.2 l (23.5 US qt)