New Holland L213 Operator's Manual page 157

Skid steer loader. compact track loader
Hide thumbs Also See for L213:
Table of Contents

Advertisement

3. Raise and curl the coupler until the back surface of the
attachment comes to rest flat against the front surface
of the coupler.
4. When the attachment is fully supported, lower the lift
arm until the lift arm is completely down on the loader
stops.
5. Roll the bucket or attachment out, stopping with the
bucket edge just off the ground.
6. Turn off the engine, unfasten seat belt, raise the re-
straint bar (if equipped), and exit the operator's com-
partment.
7. Push the two latch handles (1) down over center to
engage the lock pins into the retaining tabs on the
attachment to secure the attachment to the coupler.
WARNING
Falling object hazard!
Before operating the machine, always make
sure the bucket or attachment is securely
locked into the quick-attach plate. A loader
bucket or attachment that is not securely
locked into the quick-attach plate could come
off during loader operation.
Failure to comply could result in death or se-
rious injury.
8. Raise the attachment and slowly roll the bucket or at-
tachment out. Make a visual inspection of the lock pins
(1) engagement in the attachment lower tab slots.
• If the attachment is not properly secured to the coupler,
lower the lift arm and repeat the mounting procedure.
• Before using the attachment, the operator must operate
it through its full range of motion and confirm that the
attachment is secure and safe.
Removing the attachment
1. Lower the attachment to the ground, stop the engine,
confirm that the parking brake is set and exit the skid
steer.
2. Pull the latching handles up to the unlatched position
to release the pins from the lower attachment tabs.
NOTICE: Be sure the latch handles are fully raised.
3. Fasten your seat belt, lower the restraint bar (if
equipped), start the engine, and release the park
brake.
4. Tilt the attachment forward so that the front edge is
resting on the ground.
5. Continue tilting the coupler forward and back the skid
steer away from the attachment at the same time.
6 - WORKING OPERATIONS
W0166A
6-3
4
93106897
5
86092926

Advertisement

Table of Contents
loading

This manual is also suitable for:

200 seriesL223L215L225L218L230 ... Show all

Table of Contents