New Holland L213 Operator's Manual page 271

Loader arm stop pucks
The loader arm stop pucks are stoppers located where the loader arm and frame meet. By design, the loader arm
stop pucks allow the operator to lower the arms to the bottom position and level the bucket for precision grading.
These pucks can also be used to change the grade of a bucket. A thinner puck will lower the grade and a thicker puck
will raise the grade. The pucks installed at the factory are based on the tire size of the machine.
Frame size Tire size width
Medium 10x
Medium 10x
Medium 12x
Medium 12x
Medium Track
Medium Track
Large 12x
Large 12x
Large 14x
Large 14x
Large Track
Large Track
9 - SPECIFICATIONS
Loader geometry Loader stop height
Radial 50 mm (2.0 in)
Vertical 63 mm (2.5 in)
Radial 23 mm (0.9 in)
Vertical 40 mm (1.6 in)
Radial
23 mm (0.9 in)
Vertical 40 mm (1.6 in)
Radial 50 mm (2.0 in)
Vertical 63 mm (2.5 in)
Radial
23 mm (0.9 in)
Vertical 40 mm (1.6 in)
Radial 23 mm (0.9 in)
Vertical 40 mm (1.6 in)
9-17
Stop bolt hole location
Lower
Lower
Lower
Lower
Lower
Lower
Upper
Upper
Upper
Upper
Upper
Upper