New Holland L213 Operator's Manual page 97

(4) HYDRAULIC SYSTEM MALFUNCTION
Yellow Lamp will flash when a hydraulic
fault is detected. Use the fault code that
appeared in text display and reference it in
the trouble shooting section of this manual.
(5) ELECTRONIC SYSTEM MALFUNCTION
This yellow lamp will flash and the alarm will
sound. Use the fault code that appeared
in text display and reference it in the
troubleshooting section of this manual.
(6) SEAT BELT
RED lamp will illuminate when the seat belt is
not latched or the restraint bar (if equipped)
is raised. RED lamp will also illuminate when
the operator leaves the operator's seat.
(7) PARK BRAKE LAMP:
This Red lamp illuminates to indicate the
park brake is engaged.
Under normal conditions the park brake will
be set when:
• The park brake button is activated
(located on the right-hand control lever)
• The OPERATE button is activated
• The engine is shut off
• The engine is running and the seat belt
is not latched or the restraint bar (if
equipped) is raised
• The operator leaves the seat
(8) ENGINE PREHEATING LAMP:
In cold climate starting conditions, after
turning the key switch to run position,
this yellow engine pre-heating lamp will
illuminate, instructing the operator that
incoming air is being preconditioned for
smoother starting. The operator must wait
until the lamp goes out before attempting to
start the engine.
3 - CONTROLS AND INSTRUMENTS
3-37
3
93109329A