Instrument Cluster Display Setting - New Holland L213 Operator's Manual

Instrument cluster display setting

NOTE: The Advanced Instrument Cluster (AIC) images are shown in this section for the four switch buttons (2), (3),
(4), and (5) used to navigate through the instrument cluster. The top two switch buttons on the Electronic Instrument
Cluster (EIC) are function buttons and function the same as the POWER (5) and START (2) switch buttons on the
AIC instrument panel for the setup menu functions.
The operator may choose a continuous display of one of
the four following parameters or select cycle from the
dSPLY top level menu and momentarily display all four
of the parameters in a cycle for a few seconds each.
• HOUR - Engine hours.
• RPM - Engine RPM.
• COOLT - Engine coolant temperature.
• HOILT - Hydraulic fluid temperature.
• CYCLE - Cycle though all four parameters.
NOTE: The instrument cluster is programmed to display
the last setting selected when you sit in the seat.
To change or select from the dSPLY top level
menu
Once in the "Setup" menu, press the START button until
dSPLY appears on the screen.
1. Push the POWER button (5) to display the current se-
lection.
2. Push the START button (2) to toggle through the se-
lections.
3. Once the desired selection appears on the text display,
push the POWER button (5) to save the selection.
3 - CONTROLS AND INSTRUMENTS
3-51
1
RAIL15SSL0143CA