New Holland L213 Operator's Manual page 37

3. Install the retaining nuts. Torque the nuts to 170 N·m
(125 lb ft).
Unlock and lower the loader arm for machine operation
DANGER
Crushing hazard!
The loader arm is unsupported during support
strut removal. Do not enter or exit the opera-
tor's compartment with an unsupported loader
arm. Two persons are required during storage.
One person should remove and store the sup-
port strut while the operator remains in the op-
erator's compartment.
Failure to comply will result in death or serious
injury.
NOTE: An instructional decal on the inside of the right-
hand loader arm, just above the support strut is also avail-
able. Understand the loader arm unlock procedure before
continuing.
Placing the support strut in the storage position requires
a second person. The operator must remain in the seat
during this procedure.
1. Sit in the operator's seat, fasten the seat belt, pull the
restraint bar down (if equipped), and start the engine.
2. Press the operate button to enable the hydraulics.
3. Raise the loader arm until the support strut (B) is not
resting on the end of the cylinder barrel (C).
4. Instruct the second person to remove the support strut
pin (A) and place the support strut in the stowed po-
sition and reinstall the support strut pin (A). When the
second person has cleared the area, the operator may
now lower the loader arm.
5. Commence work operations or park the machine and
stop the engine.
2 - SAFETY INFORMATION
D0021B
2-21
10
931001633
11
RAIL14SSL0418AA
12
93106854A
13
93106848A