New Holland L213 Operator's Manual page 222

18. Install the cap (1) onto the quick-disconnect drain fit-
ting (2).
NOTE: Make sure the o-ring is installed on the drain fitting
(2), if it is damaged, then replace with new.
NOTE: The cap (1) is only hand tight on the drain fitting (2).
19. Install the cover (1) underneath the machine and se-
cure with the hardware (2).
20. Remove the engine oil dipstick (2) to provide
crankcase ventilation.
NOTICE: Slowly fill to avoid flooding the valve cover with
oil.
21. Use an oil spout that is smaller than the engine oil fill
neck (1), allowing air to pass around the oil fill neck.
Slowly add the correct type and quantity of oil, see the
oil table below.
NOTE: Keep the oil fill spout in the upper half of the oil fill
neck.
22. Install the engine oil fill cap.
23. Install the engine oil dipstick.
24. Start the engine and run at idle speed. Check the en-
gine oil filter and drain plug for leaks. After 2 min, stop
the engine, wait for 2 – 3 min and check the engine
oil level.
25. Install access cover and secure with bolts
26. Close rear access door and engine hood.
Engine crank case oil
Capacity - with filter change
L213, L215, L218, L220
L223, L225, L230, C227, C232, C238
Specifications
7 - MAINTENANCE
NEW HOLLAND AMBRA UNITEK MASTERGOLD SBL CJ-4
7-58
7
RAPH17SSL0169QA
8
RAPH17SSL0168QA
9
93106871
7.0 l (7.5 US qt)
9.5 l (10 US qt)