Track Tension Check - New Holland L213 Operator's Manual

Track tension check

Check the track tension every 50 h. For this procedure, the tracks, rollers, idler wheels, debris guard, and final drive
sprockets must be clean of dirt and debris.
Track tension check
1. Park the machine on firm level surface.
2. Raise, block, and support machine properly until the
tracks are about 50 mm (2.0 in) off the surface.
3. Measure from the bottom of the center roller wheel (1)
to the lower track top surface (2). The allowable track
sag is 12 – 19 mm (0.5 – 0.75 in).
Track tension adjustment
1. Use a 13 mm tool and remove the track adjustment
access cover (1) to expose the track adjustment fitting.
Increase track tension:
Add T M
UTELA
crease track tension adjustment fitting (1).
Decrease track tension:
Use a 19 mm tool and slowly turn the fitting (2)
counterclockwise. Grease will escape from the
bottom of the fitting and decrease tension.
G GR-75 grease to in-
OLY REASE
7 - MAINTENANCE
7-44
1
RAIL15SSL0356AA
2
RAIL15SSL0356AA
3
RAIL15SSL0382BA