Table of Contents
Advertisement
3053-3
6
.
Switch on the ML700 to check the adjustment.
7
.
Test the position of the BLOW PIPE SLITS in relation to the FILM POCKET
SUCKERS. Enter the SERVICE MODE, tilt the MAGAZINE SUCKER BAR, switch on
MAGAZINE SUCKING, switch on the VACUUM PUMPS.
8
.
Place the BLOWPIPE POSITIONER GAUGE TL 4957 onto the FILM POCKET
SUCKERS.
9
.
Check that the SLIT of the BLOWPIPES is just above the BLOWPIPE POSITIONER.
Note
The position of the slit in the BLOWPIPES is important to separate the films in the
MAGAZINES.
10.
If the position of the SLIT is not correct, loosen the HEIGHT ADJUSTMENT
SCREWS of the BLOWPIPES and move the BLOWPIPES up or down as required. Then
fasten the SCREWS.
12/1998
figure 2-31
BLOW PIPE SLIT
TL 4957
HEIGHT ADJUSTMENT
figure 2-32
2-36
REPLACEMENTS
KODAK AG, Stuttgart
Advertisement
Table of Contents
