ADJUSTMENTS
7
.
If the adjustment is not correct remove REAR COVER, loosen NUT on BEARING
SHAFT and rotate BEARING SHAFT up or down until SUCKER BAR is placed on
OPENER GAUGE as shown on figure 68. Check the adjustment by moving the
CASSETTE SUCKER BAR in and out. Check that the CASSETTE SUCKER BAR CAMS
do not touch either the edge of OPENER GAUGE 9193386 or the CASSETTE STOP. If
they do so raise the BEARING SHAFT.
8
.
Check that the OPENER GAUGE is still at the CASSETTE STOP.
9
.
Slightly loosen SCREW ON CAM for SWITCH S11 so that the CAM can be moved
by hand. The CAM should still be tight enough to actuate SWITCH S11.
The ACTUATOR must not
touch the SWITCH HOUSING
KODAK AG, Stuttgart
CAM
figure 4-41
4-39
3053-3
S11
SCREW
S11
12/1998