3053-3
6
.
Engage the BALL BEARING in the DETENT. See the drawing on the previous page.
7
.
Move the FILM POCKET carefully down.
8
.
Check that the MAGAZINE PIN is in the centre of SENSOR MAGAZINE ALMOST
EMPTY B16(MAE). if there is an offset sideways loosen SCREWS 1 and 2 (see the
drawing on the previous page) to move the MAGAZINE SUCKER BAR to the correct
position.
MAGAZINE
SUCKER BAR
9
.
Check that the BLOWPIPES are in the MAGAZINE RECESSES. The BLOWPIPES
must not touch the MAGAZINE WALL and they must not reach into the FILM AREA.
Pivot the MAGAZINE SUCKER BAR and check that the SUCKERS are at the
REFERENCE LINE on the FILM. If they are away from the line, loosen SCREW 1 and
move the SUCKER BAR ARM in or out as required.
REFERENCE LINE
3±0,5 mm away
from LEADING
EDGE of FILM
LEADING EDGE
of FILM
MAGAZINE
WALL
12/1998
MAGAZINE PIN
figure 4-64
FILM
BLOW PIPES
figure 4-65
4-62
ADJUSTMENTS
SENSOR
B16 (MAE)
SUCKERS
KODAK AG, Stuttgart