Table of Contents
Advertisement
3053-3
15.
Feed several loaded CASSETTES into the ML700 and unload them.
16.
Observe that the FILM is released from the CASSETTE SUCKERS after it reached
the nip of the TRANSPORT ROLLERS in the CONVEYER.
•
If the FILM is released too early increase the value of PARAMETER VACUUM OFF
TIME.
•
If the FILM is released too late decrease the value of PARAMETER VACUUM OFF
TIME.
17.
Place a self adhesive tape onto the INDICATOR LED to avoid fogging FILMS.
18.
Run several cycles with different cassette sizes to ensure proper operation.
19.
Enable the INTERLOCK OVERRIDE SWITCH and mount all PANELS.
12/1998
figure 4-57
TP8
TP7
TP3
A9X2
Adjust here
figure 4-58
MOUNTING SCREW (2)
SENSOR FOC
Sheet of plain white PAPER. It should
rest at the CASSETTE END STOP .
The sheet of plain white PAPER should rest
fully on the rear edge of the CASSETTE
STOP to avoid problems with PARAMETER "
TP6
TP5
A9X2A
TP2
TP4
TP1
A9X4
TP9
4-56
ADJUSTMENTS
VACUUM OFF"
DVM
KODAK AG, Stuttgart
Advertisement
Table of Contents
