Table of Contents
Advertisement
REPLACEMENTS
21.
Adjust STOP SCREW 2 until side 2 of the ACTUATOR BRACKET is parallel to the
MOTOR MOUNT.
22.
Adjust S10 to make it actuate 0.6 mm earlier.
23.
Fasten SCREWS and check adjustment again.
Adjustment of the CASSETTE CENTRING BRAKE for ML700 without
Mod.26
24.
Feed in a CASSETTE 18 x 24.
25.
If the CENTRING BARS do not open for approx. 2 mm on each side of the
CASSETTE after CENTRING readjust the BRAKE BELT TENSION with the Adjustment
SCREW.
26.
Feed in a CASSETTE 35 x 43 cm or 18 x 43 cm.
27.
The CENTRING BARS should now open 0.3 - 0.5 mm on each side after
CENTRING. Readjust the BRAKE BELT Tension with the ADJUSTMENT SCREW if
necessary.
KODAK AG, Stuttgart
figure 2-9
2-11
3053-3
12/1998
Advertisement
Table of Contents
