Table of Contents
Advertisement
ADJUSTMENTS
5
.
Measure the distance from the CENTRING BAR to the SENSOR B1 ( CS ).
6
.
Move CENTRING BARS out.
7
.
Move CENTRING BARS in again until the correct edge of the INDEX BAR
( depending on the selected CASSETTE ) is detected by the SENSOR B1 ( CS ).
8
.
Measure the distance from the CENTRING BAR to the SENSOR B1 ( CS ). Calculate
the difference between the measurements in step 8 and step 5. Compare it with the
following list:
9
.
If the difference is not correct open the MOUNTING SCREWS and move the INDEX
BAR for the required distance.
10
. Fasten the MOUNTING SCREWS.
KODAK AG, Stuttgart
figure 4-23
CASSETTE
40 cm X
35 cm X
30 cm X
24 cm X
10 in X
10 in V
Difference between
Step 8 and Step 5
8.0 ± 0.3 mm
8.5 ± 0.3 mm
8.0 ± 0.3 mm
4.0 ± 0.3 mm
7.0 ± 0.3 mm
2.2 ± 0.3 mm
4-21
3053-3
12/1998
Advertisement
Table of Contents
