Table of Contents
Advertisement
ADJUSTMENTS
Note
It is most important that this SCREW is tightened. If not tight, the relationship between the
two FILM POCKET TIMING DISKS and the MAGAZINE SUCKER BAR will be lost. It is then
impossible to pick up a FILM from the MAGAZINE.
10
. Tighten SCREW 1.
11
. Move the COLLAR with SCREW 2 all the way to the left and tighten the SCREW.
12
. Tighten SCREW 3.
13
. If there is an offset sideways between BLOWPIPES and the MAGAZINE
RECESSES do the following:
•
Bend the BLOWPIPE MOUNTING BRACKET carefully to
•
The BLOW PIPES must not be in the shaded areas. On newer ML700 and on
ML700 Plus the BLOW PIPES can be moved forward or backward after the LENGTH
ADJUSTMENT SCREW is made loose. After the BLOW PIPES are set to the correct
position, do not over tighten the LENGTH ADJUSTMENT SCREWS, otherwise they
dig into the BLOW PIPES and a fine adjustment is no longer possible.
BLOW PIPE MOUNTING
BRACKET
KODAK AG, Stuttgart
Centre Line of RECESS
figure 4-66
4-63
3053-3
left or right as required.
LENGTH ADJUST-
MENT SCREW.
THIS SCREW IS NOT
AVAILABLE IN
OLDER ML700s.
12/1998
Advertisement
Table of Contents
