ADJUSTMENTS
6
.
Now move the CASSETTE OPENER BRACKET down until
•
the PRESSURE BOLTS press onto the CASSETTE LID
•
the pressure on the PRESSURE BOLTS is released
•
the PRESSURE BOLTS touch the CASSETTE LID again without pressure.
7
.
Check that the CASSETTE rests tightly at the STOP and the PRESSURE BOLTS rest
on the CASSETTE LID.
8
.
Use a 2 mm Allen WRENCH to check the clearance between the edge of the
OPENER SHOVEL and the CASSETTE LATCH.
9
.
If the clearance is not correct, loosen the 2 SCREWS of the CASSETTE OPENER
BRACKET and move the OPENER SHOVEL to a distance of 2 mm (0.08 in.) from the
CASSETTE LATCH.
10.
Tighten the 2 SCREWS of the CASSETTE OPENER BRACKET.
KODAK AG, Stuttgart
figure 4-29
4-27
3053-3
12/1998