Table of Contents
Advertisement
3053-3
5
.
Carefully pivot SENSOR B6 in the indicated direction until its indicator LED turns
green. This is caused by the reflection of the infrared beam at the REFLECTIVE
STICKER.
6
.
Carefully pivot the lower end of SENSOR B6 in direction of the EXIT DOOR until the
INDICATOR LED is OFF. The infrared beam is no longer reflected back to the SENSOR.
7
.
Fasten the SENSOR MOUNTING SCREWS (2).
8
.
Hold a piece of FILM into the INFRARED BEAM. The beam is reflected back to the
SENSOR. The INDICATOR LED must turn green.
9
.
Actuate the TOP COVER INTERLOCK.
10.
Feed several loaded CASSETTES into the ML700 Plus and unload them.
11.
Observe that the FILM is released from the CASSETTE SUCKERS after it reached
the nip of the TRANSPORT ROLLERS in the CONVEYER.
•
If the FILM is released too early increase the value of PARAMETER VACUUM OFF
TIME.
•
If the FILM is released too late decrease the value of PARAMETER VACUUM OFF
TIME.
12.
Close the TOP COVER and insert the MAGAZINES.
13.
Run several cycles with various cassette sizes to ensure proper operation.
12/1998
figure 4-60
4-58
ADJUSTMENTS
KODAK AG, Stuttgart
Advertisement
Table of Contents
