Table of Contents
Advertisement
3053-3
6
.
Feed a 18x24 cm CASSETTE into the ML700.
7
.
Observe that there is a gap of 1 - 2 mm between CASSETTE (18x24 cm) and
CENTRING BAR after centring. This gap is smaller if larger CASSETTES are used
8
.
If the gap is too small the CASSETTE becomes clamped and might not be opened. If
the gap is too big the CASSETTE will not be held down by the movable CENTRING
BAR CLAMPS and might be pulled out of position by the CASSETTE SUCKER BAR.
If the gap is too small turn the ADJUSTMENT NUT ccw with an 8 mm WRENCH.
If the gap is too big turn the ADJUSTMENT NUT cw with an 8 mm WRENCH.
BRAKE BELT TENSIONER
12/1998
figure 4-15
4-14
ADJUSTMENTS
ADJUSTMENT NUT
KODAK AG, Stuttgart
Advertisement
Table of Contents
