2 - 30
FRONT SUSPENSION
TENSION STRUT CRADLE BUSHING (Continued)
(3) Remove the remaining tension strut cradle
bushing halve from the engine cradle assembly (Fig.
69).
Fig. 69 Bushing In Cradle
1 - CRADLE ISOLATOR BUSHING
2 - CRADLE
3 - TENSION STRUT TO CRADLE ISOLATOR BUSHING
INSTALLATION - TENSION STRUT CRADLE
BUSHING
(1) Install tension strut cradle isolator bushing
halve into front side of cradle mounting hole, until
squarely seated against cradle (Fig. 69).
(2) Install isolator bushing halve on tension strut
until it is seated against retaining washer as shown
(Fig. 68).
(3) Reinstall the tension strut and lower control
arm as an assembly back in the vehicle. (Refer to 2 -
SUSPENSION/FRONT/LOWER CONTROL ARM -
INSTALLATION)
LH