Table of Contents
Advertisement
4. Install the right intake camshaft position actuator.
CAUTION
!
Refer to "Fastener Notice: ".
5. Install the camshaft position actuator bolt.
Tightening torque
Tighten the camshaft position actuator bolt to 58
N⋅m (43 lb ft).
Reference: "Camshaft Position Actuator Installation -
Right Side Exhaust (Third Design): ".
Camshaft Position Actuator Installation -
Right Side Intake (Fourth Design)
Reference: "Camshaft Timing Drive Components
Cleaning and Inspection (Fourth Design): ".
1. Ensure the proper camshaft position actuator is
installed. Observe the body of the camshaft position
actuator for the "IN" marking (3). The marking is for
an intake camshaft position actuator.
CAUTION
!
Ensure the proper camshaft position actuator
is installed in the correct position. Failure to
install the proper camshaft position actuator
can effect engine performance and set an
engine code.
2. Ensure the proper camshaft position actuator is
being installed. The reluctor wheel on the 4th design
right intake camshaft position actuator (1) is indexed
in a different position compared to the 4th design left
intake camshaft position actuator (2).
3. On the right intake camshaft actuator the edge of the
reluctor wheel (1) lines up with the valley (2) of the
sprocket tooth.
Engine Mechanical:
1D-273
Advertisement
Table of Contents
Troubleshooting
