Table of Contents
Advertisement
Battery Positive Cable Replacement
Removal Procedure
NOTE
• Always use replacement cables that are of
the same type, diameter and length of the
cables that you are replacing.
• Always route the replacement cable the
same way as the original cable.
1. Remove the battery. Refer to "Battery Replacement".
2. Remove the underhood bussed electrical center
(UBEC) cover.
3. Remove the positive battery cable terminal nut (1)
from the UBEC stud.
4. Remove the positive battery cable terminal (2) from
the UBEC stud.
5. Remove the battery box. Refer to "Battery Box
Replacement".
6. Disconnect the positive and negative battery cable
clip (3) from the battery tray support bracket.
7. Disconnect the positive and negative battery cable
clip on the side of the battery tray support bracket.
8. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
9. Remove the positive battery cable terminal to starter
solenoid nut (6).
10. Remove the positive battery cable from the engine
wiring harness clip (3).
11. Remove the positive battery cable (4) lead from the
starter solenoid.
12. Cut the tape and remove the positive battery cable
from the wire loom.
Charging System:
1J-48
Advertisement
Table of Contents
Troubleshooting
