Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake - Suzuki XL7 2007 Service Manual

1C-22 Engine Electrical Devices:
Camshaft Position Sensor Replacement -
Bank 1 (Right Side) Intake
Removal Procedure
1. Remove the air cleaner assembly. Refer to "Air
Cleaner Assembly Replacement: ".
2. Disconnect the engine wiring harness electrical
connector (2) from the bank 1 intake camshaft
position (CMP) sensor.
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.
Installation Procedure
1. Install the CMP sensor.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the CMP sensor bolt.
Tightening torque
Tighten the bolt to 10 N⋅m (89 lb in).
3. Connect the engine wiring harness electrical
connector (2) to the bank 1 intake CMP sensor.
4. Install the air cleaner assembly. Refer to "Air Cleaner
Assembly Replacement: ".