Table of Contents
Advertisement
1J-45 Charging System:
Battery Current Sensor Replacement
Removal Procedure
1. Remove the negative battery cable. Refer to "Battery
Negative Cable Replacement".
2. Mark the location of the battery current sensor on the
battery cable with tape for reference during
installation.
3. Remove the tape securing the battery current sensor
to the negative battery cable.
4. Mark the location of the negative battery cable clips
and remove the clip from the cable.
5. Squeeze the negative battery cable branches
together.
NOTE
Note the orientation of the battery current
sensor prior to removal.
6. Slide the battery current sensor (1) off of the
negative battery cable.
Installation Procedure
1. Squeeze the negative battery cable branches
together.
NOTE
Ensure the battery current sensor is installed
in the correct direction and location on the
negative battery cable.
2. Slide the NEW battery current sensor (1) up onto the
negative battery cable to the location previously
marked during removal.
3. Wrap electrical tape around the battery current
sensor leg in order to secure the sensor to the
negative battery cable.
4. Install the negative battery cable clip to the cable to
the locations previously marked during removal.
5. Install the negative battery cable. Refer to "Battery
Negative Cable Replacement".
Advertisement
Table of Contents
Troubleshooting
