Camshaft Position (Cmp) Sensor Removal And Installation; Crankshaft Position (Ckp) Sensor (Engine Speed Sensor) Removal And Installation - Suzuki GRAND VITARA 2005 Service Manual

1C-9 Engine Electrical Devices:
Camshaft Position (CMP) Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Remove injector cover referring to "Cylinder Head
Cover Removal and Installation: in Section 1D".
3) Remove CMP sensor (1) from generator upper
bracket support.
Installation
Reverse removal procedure for installation noting the
following.
• Clean CMP sensor and protrusion of camshaft pulley
before installation.
• Tighten throttle body to EGR valve pipe to specified
torque.
Tightening torque
Throttle body to EGR valve pipe: 21 N·m (2.1 kgf-
m, 15.5 lb-ft)
Crankshaft Position (CKP) Sensor (Engine
Speed Sensor) Removal and Installation
S5JB0B1306013
Removal
1) Disconnect negative cable at battery.
2) Hoist vehicle.
3) Disconnect connector (1) from CKP sensor (2).
4) Remove CKP sensor from transmission case.
1
I5JB0B130005-01
Installation
Reverse removal procedure for installation noting the
following.
• Clean CKP sensor and sensor rotor teeth before
installation.
• Tighten CKP sensor bolt to specified torque.
Tightening torque
CKP sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
S5JB0B1306014
1
2
I5JB0B130007-01
(a)
I5JB0B130008-01