Ignition Coil Replacement - Bank 2 - Suzuki XL7 2007 Service Manual

1H-4 Ignition System:

Ignition Coil Replacement - Bank 2

Removal Procedure
1. Remove the air cleaner outlet duct. Refer to "Air
Cleaner Outlet Duct Replacement: ".
2. Disconnect the engine wiring harness electrical
connector(s) (5) from the ignition coil(s).
3. Remove the ignition coil bolt(s).
4. Remove the ignition coil(s).
Installation Procedure
1. Install the ignition coil(s).
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the ignition coil bolt(s).
Tightening torque
Tighten the bolt(s) to 10 N⋅m (89 lb in).
3. Connect the engine wiring harness electrical
connector(s) (5) to the ignition coil(s).
4. Install the air cleaner outlet duct. Refer to "Air
Cleaner Outlet Duct Replacement: ".