Table of Contents
Advertisement
1J-51 Charging System:
Installation Procedure
1. Position the battery (1) in the battery box (2).
2. Install the washer (3) and battery hold down (4).
CAUTION
!
Refer to "Fastener Notice: ".
3. Install the hold down bolt (5).
Tightening torque
Tighten the hold down bolt to 15 N⋅m (11 lb ft).
4. Install the positive and negative battery cables. Refer
to "Battery Negative Cable Disconnection and
Connection".
5. Position the battery lid (3) so that the alignment tabs
(2) are in position.
6. Lock the locking tabs (1) on the side of the battery
box.
7. Install the PCM (2) on the battery box cover (1).
Advertisement
Table of Contents
Troubleshooting
