Table of Contents
Advertisement
15. Remove the fuel feed pipe from the fuel/EVAP/brake
pipe assembly clips.
Installation Procedure
1. Install the fuel feed pipe to the fuel/EVAP/brake pipe
assembly clips.
2. With the aid of an assistant, position and install the
fuel/EVAP/brake pipe clips (2) to the underbody
studs.
3. Install the push pin (1) to the underbody side rail
hole.
CAUTION
!
Refer to "Fastener Notice: ".
4. Connect the right rear brake line fitting to the rear
brake hose.
Tightening torque
Tighten the fitting to 18 N⋅m (13 lb ft).
Fuel System:
1G-41
Advertisement
Table of Contents
Troubleshooting
