1B-12 Aux. Emission Control Devices:
Evaporative Emission Canister
Replacement
Removal Procedure
NOTE
The EVAP emissions canister is located
under the center of the vehicle. It has 3 EVAP
line connections:
• The EVAP fresh air
• The EVAP vent
• The EVAP purge
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
CAUTION
!
Clean all fuel pipe connections and
surrounding areas before disconnecting the
fuel pipes to avoid contamination of the fuel
system.
2. Disconnect the EVAP canister fresh air hose/pipe
from the fuel tank fresh air hose/pipe (2). Refer to
"Plastic Collar Quick Connect Fitting Service: ".
3. Disconnect the EVAP canister vent hose/pipe from
the EVAP canister. Refer to "Plastic Collar Quick
Connect Fitting Service: ".
4. Disconnect the EVAP canister purge hose/pipe (1)
from the EVAP canister.
5. Remove the EVAP canister-to-underbody nuts (3).
6. Lower the EVAP canister.
7. Disconnect the EVAP vent solenoid electrical
connector (1).
8. Remove the EVAP canister (4) from the vehicle.