Table of Contents
Advertisement
4. Install the right exhaust camshaft position actuator.
CAUTION
!
Refer to "Fastener Notice: ".
5. Install the camshaft position actuator bolt.
Tightening torque
Tighten the camshaft position actuator bolt to 58
N⋅m (43 lb ft).
Reference: "Crankshaft Sprocket Installation (Third
Design): ".
Camshaft Position Actuator Installation -
Right Side Exhaust (Fourth Design)
1. Ensure the proper camshaft position actuator is
installed. Observe the body of the camshaft position
actuator for the "EX" marking (1). The marking is for
an exhaust camshaft position actuator.
2. Ensure the proper timing mark is used. Observe the
outer ring of the camshaft position actuator for the
triangle marking (2). The marking is for alignment to
the highlighted timing chain link on the right side of
the engine.
CAUTION
!
Refer to "Torque Reaction Against Timing
Drive Chain Notice".
3. Use an open wrench on the hex cast into the
camshaft in order to prevent camshaft rotation when
tightening the camshaft position actuator bolt.
4. Install the right exhaust camshaft position actuator.
CAUTION
!
Refer to "Fastener Notice: ".
5. Install the camshaft position actuator bolt.
Tightening torque
Tighten the camshaft position actuator bolt to 58
N⋅m (43 lb ft).
Reference: "Crankshaft Sprocket Installation (Fourth
Design): ".
Engine Mechanical:
1D-275
Advertisement
Table of Contents
Troubleshooting
