Suzuki GA413 Service Manual page 132

3C-4 STEERING WHEEL AND COLUMN
1. Steering wheel
2. Mounting bolt
3. Driver air bag (inflator) module
1. Driver air bag (inflator)
module connector
2. Horn connector
DRIVER AIR BAG (INFLATOR) MODULE
(FOR VEHICLE WITH AIR BAG SYSTEM)
REMOVAL
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to DISABLING AIR BAG SYS-
3) Remove driver air bag (inflator) module mounting bolts at right
4) Remove driver air bag (inflator) module from steering wheel.
5) Disconnect yellow connector of driver air bag (inflator) module
3. Driver air bag (inflator)
module
4. Connector clamp
INSPECTION
WARNING:
When handling an air bag (inflator) module, be sure to
read SERVICE PRECAUTIONS in this section and ob-
serve each instruction. Failure to follow them could
cause a damage to the air bag (inflator) module or result
in personal injury.
TEM of SERVICE PRECAUTIONS in this section.
and left side of steering wheel.
and horn connector in order ( i) " iv) ) shown in the figure.
WARNING:
Never disassemble driver air bag (inflator) module or
measure its resistance. Otherwise, personal injury may
result.