Re-Installing The Development Unit - Ricoh B064 SERIES Service Manual

MAIN MACHINE (B064 SERIES/B140 SERIES/B246 SERIES/D052 SERIES)
Rev. 04/2008
⇒

Re-installing the Development Unit

1. Push the development unit to the right
2. While continuing to hold the unit to the right, push it into the machine.
3. Confirm that the pin [A] goes into the left side of the oval hole [B] in the
development unit plate.
4. Push the development unit in completely
.
5. Make sure you can see the horizontal pin in front of the plate as shown below.
NOTE: If you cannot move the development unit plate behind the horizontal
pin, turn the front gear of the unit to the left and try again.
6. Make sure the pipeline shutter is rotated down to the open position.
7. Reattach all removed parts.
SM
CÓPIA NÃO CONTROLADA
2
3
[B]
.
until it stops, then push it to the left
Correct!
Incorrect!
1-17
CÓPIA NÃO CONTROLADA
[A]
1
B246I999.WMF
B246I999A.WMF
B064 Series/B140 Series
/B246 Series/D052 Series