Display Symbols And Key Operation - A&D BM series Instruction Manual

4. Display Symbols and Key Operation

Display
Processing indicator
Stabilization indicator
Standby indicator
of power supply
Weighing data or stored data
The current data number
Active processing indicator
Density mode, Display lock
Prior notice indicator of
automatic self calibration
The interval memory function is used to store the weighing data periodically. Refer to "12. Data Memory".
Key operation
Press and release the key immediately or "Click the key" ...................................................................
Press and hold the key (for approx. 2 seconds) ..............................................................................
Key When pressed and released
Turns the display on and off. The standby indicator is displayed when the display is turned off.
When the display is turned on, the weighing mode is enabled. If the password function is
used, pa55
the Password Before Weighing".
This key is available anytime. Pressing the key during operation will interrupt the operation
and turn the display off.
Cancels the operation when performing
function settings.
Enters the calibration mode using the internal
mass.
Switches the preset weighing units stored
in the function table.
Refer to "5. Weighing Units".
In the weighing mode, turns the minimum
weighing value on and off.
In the counting or percent mode, enters
the unit mass storing mode or reference
mass storing mode.
The key to output the weighing data to a
printer or personal computer (or store it in
memory) depending on the function table
settings.
The key to set the display to zero.
The key to turn the ionizer on and off.
The key to monitor the time and date, and the environmental sensors (temperature, humidity, barometric
pressure), for several seconds. Refer to "6.6. Monitoring the Clock and Environmental Sensors".
BM series
is displayed to prompt you to enter a password. Refer to "15.4. Entering
(Factory setting = output)
The amount of stored data with data memory function
Humidity (%)
Blinking indicators
When pressed and held (approx. 2 seconds)
Displays other items of the calibration menu.
Performs automatic response adjustment.
Displays the function table menu.
Refer to "10. Function Table".
Performs a repeatability test when pressed
and held for another 2 seconds after the
function table menu is displayed.
Refer to "6.7. Repeatability Test".
No function at the factory setting.
By changing the function table:
"Title block" and "End block" for GLP /
GMP report are output.
The data memory menu is displayed.
17
Response indicator for approx. 30
seconds when weighing starts.
Right and left glass door indicator
Barometric pressure (hPa)
Standby indicator of
interval memory function
ION mark
Units.
Refer to "5. Weighing Units".
Active indicator of
interval memory function