A&D BM series Instruction Manual page 70

Recalling the memory data
Confirm that the "Data memory (
1 Press and hold the
is displayed, and then release the key. The type of data appears in
the upper left of the display as shown to the right.
2 Press the
PRINT
Recall the data in memory using the following keys.
key ..... To proceed to the next data set.
RE-ZERO
key ......... To go back to the previous data set.
MODE
key .......... To transmit the current data using the RS-232C
PRINT
With held down, press the
RANGE
key ............. To exit the memory recall mode.
CAL
3 Press the
CAL
Transmitting all memory data at one time
Confirm that the "Serial interface (
Refer to "10. Function Table" and "16.2. Connecting to Peripheral Equipment".
1 Press and hold the
until is displayed, and then release the key.
reCall
2 Press the
RANGE
3 Press the
PRINT
blinking.
5 Press the
RE-ZERO
"go" blinking.
6 Press the
PRINT
RS-232C interface.
7 The balance displays
transmitted.
Press the
CAL
)" parameter is set to "
data
key (for approx. 2 seconds) until
PRINT
key to enter the memory recall mode.
interface.
To delete the current data.
key to return to the weighing mode.
)" parameters are set properly.
5if
key (for approx. 2 seconds)
PRINT
key to display
out
key to display
out " n " o
key to display
key to transmit all data using the
when all data is
Clear
key to return to the weighing mode.
1
key
CAL
.
with "no"
with
out " g " o
68
".
reCall
Weighing data
without time and date
Weighing data with
time and date
Press and hold
(approx. 2 seconds)
Transmit all data
Indicators
BM series