A&D BM series Instruction Manual page 72

Transmitting the memory data
Notes
Confirm that the "Serial interface (
Refer to "10. Function Table" and "16.2. Connecting to Peripheral Equipment".
Confirm that the "Data memory (
1 Press and hold the
until is displayed, and then release the key.
out
2 Press the
PRINT
blinking.
3 Press the
RE-ZERO
"go" blinking.
4 Press the
PRINT
the RS-232C interface.
5 The balance displays
is output.
Press the
CAL
Deleting data stored in memory
1 Press and hold the
until is displayed, and then release the key.
out
2 Press the
RANGE
3 Press the
PRINT
blinking.
4 Press the
RE-ZERO
"go" blinking.
5 Press the
PRINT
6 The balance displays
weighing mode when all the data has been deleted.
5if
data
key (for approx. 2 seconds)
PRINT
key to display
out " n " o
key to display
key to transmit all memory data using
when all memory data
Clear
key to return to the weighing mode.
key (for approx. 2 seconds)
PRINT
key to display
Clear
key to display
Clr " n " o
key to display
key to delete all data.
and returns to the
end
)" parameters are set properly.
)" parameter is set to "
with "no"
with
out " g " o
.
with "no"
with
Clr " g " o
70
".
2
Press and hold
(approx. 2 seconds)
Press and hold
(approx. 2 seconds)
BM series