A&D BM series Instruction Manual page 68

Storing the weighing data
Note If " " blinks in the upper left of the display, delete the data in memory.
Clr
1 Set the "Data memory (
2 Specify whether or not to add the time and date using the "Time/Date output (
3 The storing mode depends on the "Data output mode (
Four modes are available to store data.
Key mode ........................... When the
Auto print mode A .............. When the displayed value is stable and the conditions of "Auto print
Auto print mode B .............. When the displayed value is stable and the conditions of "Auto print
Interval mode ...................... Weighing data is stored at an interval specified in "Interval time (
Enabling the data memory function
1 Press and hold the
until is displayed, and then release the key.
ba5fnc
2 Press the
RANGE
3 Press the
PRINT
4 Press the
RANGE
5 Press the
RE-ZERO
6 Press the
PRINT
7 Press the key to return to the weighing mode.
CAL
)" parameter to "
data
PRINT
balance stores the weighing data.
polarity", "Auto print difference" and zero point (reference value) are met,
the balance stores the weighing data.
polarity", "Auto print difference" and last stable data (reference value)
are met, the balance stores the weighing data.
Press the
PRINT
key (for approx. 2 seconds)
RANGE
key several times to display
key.
key several times to display
key to display
data 1
key to store the setting.
" (To store the weighing data).
1
)" parameter setting.
prt
key is pressed and the displayed value is stable, the
key to start and stop this mode.
.
dout
.
data
.
66
)" parameter.
5-td
Press and hold
(approx. 2 seconds)
Press several times
Press several times
)".
int
BM series