A&D BM series Instruction Manual page 69

Display symbols for data memory
Number of data
in memory
Memory full
Data number of the data
currently displayed
Notes
When weighing data is being stored in memory, the data can be output to a personal
computer using the RS-232C interface at the same time.
" " indicates that memory is full or the memory capacity has been reached. More data
fUl
cannot be stored unless the memory data is deleted.
Automatic self calibration cannot be used while the interval memory mode is active.
The following commands cannot be used during data storage.
Query command for weighing data.
Q
Query command for stable weighing data.
S
Query command for weighing data.
SI
Query command for continuous weighing data.
SIR
Setting the function table
Parameter settings for each output mode are as follows:
Mode
Key mode
Auto print mode A
Auto print mode B
Interval mode
Additional parameter settings, as follows:
No
Data number
Yes
No
ID number
Yes
BM series
Memory data being displayed
Item Data output
mode
prt 0
prt 1
prt 2
prt 3
d-no off
d-no on
5-id off
5-id on
Weighing data
being displayed
Auto print polarity,
difference
Not used
ap-a 0 to 2
ap-b 0 to 2
Not used
No
Time only
Time and date
Date only
Both
67
Interval memory
standby indicator
Interval memory
active indicator
Data memory
Interval time
function
data 1
data 1 Not used
data 1
data 1 int 0 to 8
5-td 0 200 sets
5-td 1
5-td 2 100 sets
5-td 3