A&D BM series Instruction Manual page 75

Entering the density of a liquid
Two ways to set the density of a liquid are available in the function table, "Liquid density input (
entering the water temperature or by entering the density directly.
1 Press the
MODE
Press and hold the
temperature" or "liquid density". In the density mode : The unit is "g (gram)". The
processing indicator (
If you cancel the density mode, press the
Entering the water temperature
2 Press and hold the
temperature currently set (unit: °C, factory setting : 25°C) is
displayed. Use the following keys to change the value.
(+)key .... To increase the temperature by one degree.
RE-ZERO
(-)key..........To decrease the temperature by one degree.
MODE
key............To store the new water temperature, display
PRINT
key...............To cancel the change and return to the density mode.
CAL
The relation between the water temperature and density
°C +0
0 0.99984 0.99990 0.99994 0.99996 0.99997 0.99996 0.99994 0.99990 0.99985 0.99978
10 0.99970 0.99961 0.99949 0.99938 0.99924 0.99910 0.99894 0.99877 0.99860 0.99841
20 0.99820 0.99799 0.99777 0.99754 0.99730 0.99704 0.99678 0.99651 0.99623 0.99594
30 0.99565 0.99534 0.99503 0.99470 0.99437 0.99403 0.99368 0.99333 0.99297 0.99259
40 0.99222 0.99183 0.99144 0.99104 0.99063 0.99021 0.98979 0.98936 0.98893 0.98849
Entering the density directly
Press and hold the
currently set (unit : g / cm
displayed.
Use the following keys to change the value.
The range to set the density is 0.0000g / cm
(+)key ..... To increase the value of the digit selected.
RE-ZERO
(-)key .......... To decrease the value of the digit selected.
MODE
key .......... To select the digit to change the value.
RANGE
key ............ To store the change, display
PRINT
key ............... To cancel the change and return to the density mode. (Step 1)
CAL
BM series
key as necessary to select the density mode.
key (for approx. 2 seconds) to select to "water
MODE
) blinks. Response adjustment is off.
key (for approx. 2 seconds). The water
MODE
(0°C is displayed after 99°C)
(99°C is displayed after 0°C)
and return to the density mode. Proceed
end
to Step 1.
Proceed to Step 1.
+1 +2 +3
key (for approx. 2 seconds). The density
MODE
3
, factory setting : 1.0000g / cm
key.
MODE
( ldin 0 )
+4 +5
( ldin 1 )
3 3
to 1.9999g / cm .
and return to the density mode. (Step 1).
end
73
Press and hold
(approx. 2 seconds)
+6 +7
3
) is
Press and hold
(approx. 2 seconds)
): by
ldin
+8 +9
3
g/cm