A&D BM series Instruction Manual page 76

Measuring the density
Note If the liquid temperature or the type of liquid is changed during measurement, input
the value of the liquid density again as necessary. The density display is four decimal
places. The minimum display cannot be changed with the
The density (or specific gravity) is displayed after "Weighing
in air" and " Weighing in liquid". The procedure of each
measurement is as follows:
g : gram. : the processing indicator
1 Enter the density mode. (g lights.
Place nothing on both pans and press the
to display zero.
2 Place the sample on the pan in air (g lights.
and wait for the weight value to be stable.
To store or output the weight value, press the
Press the
RANGE
in air and proceed to the next step.
Note If negative value or
displayed, the
3 Move the sample to the pan in liquid (g lights.
and wait for the weight value to be stable.
To store or output the weight value, press the
Press the
RANGE
liquid and proceed to the next step.
Note If e (out of range) is displayed, the
key is inactive.
4 To store or output the density value, press the
key. (Unit : . g turns off.
Press the
RANGE
and proceed to Step 2.
5 If the liquid temperature or the type of liquid is changed
during measurement, input the value of the liquid density
again as necessary.
6 Press the
MODE
specific gravity
(
blinks.)
key to confirm the weight value
e
(out of range) is
key is inactive.
RANGE
key to confirm the weight value in
lights.)
key to measure another sample
key to proceed to other modes.
)
Weighing in air.
key
RE-ZERO
g lights.
blinks.)
Weighing in air.
key.
PRINT
g lights.
lights.)
key.
PRINT
Weighing in liquid.
g lights.
RANGE
PRINT
Density display.
g turns off.
74
key.
RANGE
From "Entering the
density of a liquid"
blinks.
Place sample on
the pan in air
blinks.
Output or store
Move sample from
the pan in air to the
pan in liquid
lights.
Output or store
lights.
Output or store
Remove sample
BM series