Selecting Units And Weighing Modes - A&D BM series Instruction Manual

Selecting Units and Weighing Modes

5.3.
Preset the sequence of displaying units and
weighing modes to fit the frequency of use.
Refer to "5.2. Storing Active Units".
Press the key in the weighing mode to
MODE
display the units and weighing modes in order.
For the BM-20 and BM-22, the units preset at
the factory, (Milligram) and
displayed in this order.
For the BM-252, BM-500, BM-300 and BM-
200, the units preset at the factory,
and (Milligram), are displayed in this order.
Density mode
To use the density mode, it must be stored in
the function table as described on page 21.
Refer to "14. Density Measurement" for
details about the mode.
To select the density mode, press the
key until the processing indictor
MODE
blinks with the unit "g" displayed.
The unit sequence of the factory settings.
(Gram), are
(Gram)
22
Turning the display on.
BM-20
BM-22
Counting mode
Percent mode
Ounce (Avoir)
Troy Ounce
Metric Carat
Momme
Pennyweight
Grain (UK)
Tola (India)
Messghal
Density mode
BM-252
BM-500
BM-300
BM-200
Tael
BM series