HP 8712ES User Manual page 69

Table 3-1
S 11 Refl Port 1 S 21 Fwd Trans
Frequency 0.300 MHz to
Range 1300 MHz
(HP 8712ES)
Frequency 0.300 MHz to
Range 3000 MHz
(HP 8714ES)
Measurement S
11
Channel 1
Detection Narrowband
Mode
Measurement A/R
Paths
• Press Fault Location
the cable fault location. (The
the Cable menu.)
Depending on your selection, the analyzer is set to one of the following
configurations. (The
discussed in the Option 100 User's Guide Supplement.)
Measurement Configurations from the BEGIN Key
0.300 MHz to
1300 MHz
0.300 MHz to
3000 MHz
S
21
Narrowband
B/R
The following measurement configurations apply to all of the
measurement types in the previous table:
Power Level
Measurement
Channel 2
Format
Number of Points
Sweep Time Mode
Sweep Triggering
Averaging
System Bandwidth
1. Factory preset power level is user-defined by using the "Pwr
Level at Preset" softkey. The factory default is 0 dBm.
ES User's Guide
Using the BEGIN Key to Make Measurements
(Option 100 only) if you want to measure
Fault Location
SRL and Fault Location
S 12 Rev Trans S 22 Refl Port 2
0.300 MHz to 0.300 MHz to
1300 MHz 1300 MHz
0.300 MHz to 0.300 MHz to
3000 MHz 3000 MHz
S S
12 22
Narrowband Narrowband
A/R B/R
Factory preset power level
Off
Log Mag
201
Auto
Continuous
Off
Medium Wide
Making Measurements
selection is under
configurations are
Conversion
Power
Loss
10 MHz to 10 MHz to
1300 MHz 1300 MHz
10 MHz to 10 MHz to
3000 MHz 3000 MHz
Power Conversion
Loss
Broadband Broadband
Internal Internal
B* B*/R*
1
3-17