HP 8712ES User Manual page 318

Bandwidth
Baud Rate
Beeper Volume
BEGIN
Begin
Frequency
Begin Limit
BOOTP on OFF
Hardkey/Softkey Reference
B
Softkey in the marker search menu. Automatically calculates −3 dB
(default) or other user-specified bandwidth, center frequency, and Q of
a bandpass filter.
See "Using Markers" on page 4-3
Marker Search
MARKER
Softkey in the select copy port menu. Sets the transmission baud rate
of the analyzer for serial devices. Make sure the rate you set matches
the requirement of the output device (see its manual for details).
Access keys:
HARDCOPY
Softkey in the system configuration menu. Sets the analyzer beeper
volume from off (0) to high (100). The default is 90.
Access keys:
SYSTEM OPTIONS
Hardkey located to the left of the disk drive. An appropriate place to
begin measuring any of the four types of devices in the begin menu.
Recommended for one channel measurements.
See "Using the BEGIN Key to Make Measurements" on page 3-14
more information.
Softkey used to define a limit line.
See "Using Limit Testing" on page 4-28
Access Keys:
DISPLAY
Add Max Line or
Softkey used to define a limit line.
See "Using Limit Testing" on page 4-28
Access Keys:
DISPLAY
Add Max Line or
Softkey in the BOOTP setup menu. When toggled to ON, enables a
BOOTP request when the analyzer boots up. Default setting is OFF.
See The LAN Interface User's Guide Supplement for more information.
Access Keys:
SYSTEM OPTIONS
8-12
for more information.Access Keys:
Select Copy Port
System Config
for more information.
Limit Menu
Add Min Line
for more information.
Limit Menu
Add Min Line
LAN
Add Limit
Add Limit
BOOTP Setup
ES User's Guide
for