Table of Contents
Advertisement
First Edition - Second Printing
MOVING A DISABLED MACHINE
Tow the machine only when no alternative is possible,
since this operation may result in serious damage to
the transmission. When possible, repair the machine
on site.
When the machine shall absolutely be towed:
•
Unlock the parking brake.
•
Tow the machine for short distances and at
a low speed only (less than 5 km/h).
•
Use a rigid drawbar.
•
Select the two-wheel steer.
•
Set the forward/back speed lever to neutral
position.
•
Raise the front wheels of the machine.
•
When possible, start the engine and use the
hydraulic drive and the braking system.
Part No. 57.0009.0540
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Transporting The Machine
UNLOCKING THE NEGATIVE BRAKE.
To unlock the negative brake of a faulty machine,
use the four screws 31 on the two sides of the rear
differential casing as follows:
•
Loosen the four counter-nuts fixing screws 31,
then move the nuts backwards by approx. 8 mm.
•
Tighten screws 31 so as to fasten them onto the
pressure plate.
•
Using a wrench, tighten the screws 31 in an
alternate sequence by 1/4 turn a time so as to
compress the Belleville washers and disengage
the braking disks. Tighten max. by one turn.
•
After the manual release, adjust screws 31 to
obtain a jut of 30 ± 0.5 mm in relation to the arm.
Operator's Manual
93
Courtesy of Crane.Market
Advertisement
Table of Contents
